Bose X Bedienungsanleitung

BOSEAVIATIONHEADSETOWNER’SMANUAL

Microphone boom relocationTo suit your personal preference, the Headset boom can be moved from one earcup to the other. This requires the use of a sma

6.Route the boom cable to the earcup on which the boom is to be installed. If the boom is to be installed on the right earcup. do not route the cable

In Case of DifficultyExperience in using the Headset vAW help estaUish your sense of how it should sound.If you notice a probfem. the foliowing outlin

ProblemPopping sound aodibSe with Headset turned on in a loud environment.What to do• Adjust the earcup fit toeliminaie the sound.• Inspect the seal

carton, contact the Bose organization in your country for a new carton available atantxninalcharge:C. Label and ship, freight prepaid, to the a

Active Noise ReductionActive Noise Reduction Bandwidth:30-700 HzNoise Floor35d8ASPLMaximum Ambient Noise LevelApproximately 118 d8 SPL at full cancell

C Bc60 Corpory.cn The Mouitairi. Frdpvtghan^. NU 0170 vd 168 USA {U»)9T9-7^ TAX<508)87^^1 PNM6068 Rev.1Better sound ^uvugh research*

OperationalAdvisoriesAs with any complex electronic device, it is possible for this headset toexperierx« a failure during operation. Such a falure may

Congratulations on your purchase of the Bose' Aviation Headset.DescriptionThe Bose AviaUon Headset uses an adviced combination of electfoacousti

To change the height of the earcupsThis adjustment is most easily made with the Headset off your head.1. GrasptheheadbarKJpadinoneh^dand the pivot bl

To ptóce the mic for best communication clarity and noise rejection, locate the microphone housing so that it is just brushing your lips. The microph

Care and Maintenancestowing the HeadsetBose’ recommends that you do not leave the Headset in your cockpit or in direct sunlight between flights, fcx s

Cleaning instructionsClean the Headset exterior and cushions by v/iping them v/iih a rricxst cloth. Mild soap may be used if necessary. Do not immerse

To install a new linerLift the old foam liner out of the earcup.Place the nesv foam liner in the earcup cavity. NOTE: The left and right foam liners a

PivotBlockFigure 7Unwind the cable and remove it from the groove.3. If you are changing it from right side to left, route the cable in a small loop t